Water Heater Efficiency and Maintenance

Mineral deposits on pressure release valves or corrosion on fittings coming out of the water heater are signs of leakage that should be addressed. Photo credit: Jim Troth, homeinspectionsinohio.com.

By Pat Keegan and Brad ThiessenBy Pat Keegan and Brad Thiessen

Certified home inspectors estimate the life span of a water heater to be about 10 years. Some manufacturers suggest 12 to 13 years, but some water tanks can last more than 40 years before the heating element finally gives out. That said, it’s wise to replace a water heater before it fails because sometimes failure includes a ruptured tank or a massive leak that can do a lot of damage.

Mike Stephens, Cotton Electric Co-op’s Energy Use Advisor, inspects a water heater. Photo credit: Cotton Electric Cooperative.

The life span of a conventional water heater (one with a tank) depends on factors such as the volume of water cycled through it, the hardness (mineral content) of the water and the tank’s interior coating. Many water heaters come with a warranty as long as 12 years. Presumably, a longer warranty indicates higher quality and the chances of longer life. These warranties usually only cover the cost of a replacement tank; they typically do not include the cost of labor to install it or the costs from flood damage if the tank fails.

There are a few warning signs that your water heater tank or heating element may be failing:
• Water leaking from the tank or pooling on the floor underneath it
• Rust, corrosion or mineral deposits around fittings or release valves
• The water temperature from your faucets is dropping

Most experts believe that an important water heater maintenance practice is to drain the tank every year or two. Allstate.com provides an excellent step-by-step guide. However, Ken Maleski, the residential energy advisor at Central Electric Cooperative in Pennsylvania, recommends that if your tank has not been drained in the past six to seven years, you should avoid doing so because draining could remove sediment in such a way that a leak could develop.

Insulating your water heater and keeping the temperature at 120 degrees or below are two ways to save money on your utility bill. Photo credit: Water Heater Repair Portland.

Here are a few simple steps you can take to increase the efficiency of your water heater:
• Insulate the first 6 to 10 feet of easily-accessed hot water line where it exits the tank.
• If the tank is warm to the touch or is in a cold location like your garage, consider insulating it with a heater blanket. However, check the owner’s manual first to make sure doing so won’t void the warranty. If you have a gas or propane water heater, be careful the blanket doesn’t block the unit’s air supply.
• Keep your water temperature to 120 degrees or less. This will help you save money on your heating bill and ensure longer life for pipes and gaskets.

Installing a carbon monoxide detector near your natural gas or propane water heater is a critical safety measure.

Keep safety in mind. If you have a gas or propane water heater, protect your family from the “silent killer” of carbon monoxide gas. Pick up a carbon monoxide detector from the hardware store and install it near the heater.

Opportunities to save money on your hot water budget abound throughout the house. Showering uses almost 17 percent of our indoor water use, so you can save money by installing efficient shower heads. Replacing older dishwashers and washing machines with more efficient models will also reduce your energy bills. You should repair any leaky faucets, as a drip every second can add up to $35 per year.

When it’s time to purchase a new water heater, there are many options available. Be sure to check with your electric co-op. Some co-ops offer rebates on energy efficient models. Others offer incentives for water heaters with large tanks or for installing a switch that can be triggered remotely to turn the water heater off for brief periods of high energy demand. Last but not least, check out Energy.gov’s excellent article on selecting a new water heater.

This column was co-written by Pat Keegan and Brad Thiessen of Collaborative Efficiency.